CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
11.
Remove the three mounting bolts from the lower cover. Pry the bottom of the cover away from the block about an inch, and use a socket or similar
tool to hold it there.
12.
Remove the oil pump housing bolt to the left and below the front balancer shaft.
13.
Install the oil seal retainer from the kit on the pump housing with the bolt you just removed. Torque the bolt to 12 Nm (8.7 lb-ft).
14.
Reinstall the lower cover bolts, making sure the rubber seal seats properly in the cover. Torque the bolts to 12 Nm (8.7 lb-ft).
15.
Reinstall the crankshaft pulley. Use the special tools and a torque wrench to torque the pulley bolt to 245 Nm (181 lb-ft). Make sure you use a
torque wrench; do not use an impact wrench.
16.
Reinstall the splash shield mounting bolts. Torque the bolts to 12 Nm (8.7 lb-ft).
