CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
43. Remove the special tool. Push in the cylinder end seal with your finger.
CAUTION: Take care not to damage the cylinder end seal with the threads and burrs at the staked position of the gearbox.
44. Install a puller yoke to the gearbox housing, then clamp the puller yoke in a vise with son jaws as shown.
CAUTION: Do not clamp the cylinder.
45. Grease the inside surface of the cylinder end, then install the cylinder end into the cylinder and tighten it to the specified torque.
46. Remove the puller yoke from the gearbox housing.
47. Stake the point of the cylinder.
NOTE: Stake the cylinder in the position opposite from where the stake was removed during disassembly.
48. Select the 32 mm shim(s). Shim selection:
NOTE: Only reinstall the original 32 mm shim(s) when the steering gearbox is reassembled without replacing the pinion shaft, valve housing, and
gear box housing with new ones. If the pinion shaft, valve housing, and gearbox housing are replaced, select the new shim(s) as follows.
a. Set the four 32 mm shims on the bearing surface of the gearbox housing. Total thickness of the four shims should equal no more than 0.70 mm.
Shim set: four 32 mm shims (Thickness: 0.10 mm, 0.15 mm, 0.20 mm, 0.25 mm respectively). The four 32 mm shims do not have thickness
