CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
10. Install the steering joint, and reconnect the steering shaft and pinion shaft.
NOTE: Make sure the steering joint is connected as follows:
a. Insert the upper end of the steering joint onto the steering shaft (line up the bolt hole with the flat on the shaft), and loosely install the upper
joint bolt.
b. Slip the lower end of the steering joint onto the pinion shaft (line up the bolt hole with the groove around the shaft), and loosely install the
lower joint bolt. Be sure that the lower joint bolt is securely in the groove in the pinion shaft.
c. Pull on the steering joint to make sure that the steering joint is fully seated. Then tighten the upper and lower joint bolts.
11. Center the cable reel by first rotating it clockwise until it stops. Then rotate it counterclockwise approximately two turns. The arrow mark on the
label should points straight up. Reinstall the steering wheel.
12. Install the steering joint cover with the clamps and clips.
13. Connect the shift linkage. Refer to Transmission and Drivetrain.