CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
3. Hold the 1st gear, and make sure the 3rd gear turns freely in the direction shown. Also make sure the 3rd gear does not turn in the opposite
direction.
4. Install the needle bearing, thrust washer and 1st gear collar in the 1st/3rd gear assembly, then install them in the 1st-hold clutch.
5. Wrap the shaft splines with tape to prevent damage to the O-rings, and install two new O-rings in the countershaft.
6. Install the 1st/3rd gear and 1st-hold clutch assembly on the countershaft.
7. Align the shaft splines with those of 1st-hold clutch, 1st gear collar and 3rd gear, then press the countershaft into 3rd gear using a press.
NOTE:
-
Place an attachment between the press and countershaft to prevent damage to the shaft.
-
Stop pressing the countershaft when the 1st-hold clutch contacts the final drive gear.
