CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
3. After installing the thrust shim, install the outer race in the transmission housing using the special tools as shown.
NOTE:
-
Install the outer race squarely in the transmission housing.
-
Check that there is no clearance between the outer race, shim and transmission housing.
4. With the mainshaft, countershaft and secondary shaft removed, install the differential assembly, and torque the transmission housing.
-
TORQUE: 44 Nm (33 ft. lbs.).
NOTE: Install the gasket when checking starting torque.
5. Rotate the differential assembly in both directions to seat the bearings.
6. Measure the starting torque of the differential assembly with the special tool and a torque wrench.
-
STANDARD:
New bearings: 2.7 - 3.9 Nm (24 - 35 inch lbs.).
Reused bearings: 2.5 - 3.6 Nm (22 - 32 inch lbs.).
NOTE:
-
Measure the starting torque at normal room temperature in both directions.
-
Changing the shift to the next size will increase or decrease starting torque about 0.3 - 0.4 Nm (3 - 3 inch lbs.).
-
To increase the starting torque, increase the thickness of the shim. To decrease the starting torque, decrease the thickness of the shim.
