CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Carrier Bearings: Service and Repair
NOTE: Check the bearings for wear and rough rotation. If the bearings are OK, removal is not necessary.
BEARING REPLACEMENT
1. Remove the tapered roller bearings using the special tools, a bearing separator and a press as shown.
2. Install the new tapered roller bearings, using the special tool and a press as shown. Use the small end of the special tool to install the bearings.
NOTE:
-
The bearing and outer race should be replaced as a set.
-
Inspect and adjust the bearing preload whenever a bearing is replaced.
-
Press in the bearings on securely so that there is no clearance between the bearings and differential carrier.
BEARING OUTER RACE REPLACEMENT
TOOL REQUIRED
-
07749-0010000 Driver
-
07HAD-SF10100 Driver Attachment
NOTE:
-
Replace the bearing with a new one whenever the outer race is to be replaced.
-
Do not use shim(s) on the torque converter housing side.
-
Adjust preload after replacing the bearing and outer race.
-
Coat all parts with ATF during installation.