CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
6. Inspect the fingers of the diaphragm spring for wear at the release bearing contact area.
7. Inspect for warpage using a straight edge and feeler gauge. Measure across the pressure plate.
-
Standard (New): 0.03 mm (0.001 inch) max.
-
Service Limit: 0.15 mm (0.006 inch)
-
If the warpage is more than the service limit, replace the pressure plate.
INSTALLATION
1. Install the ring gear holder.
2. Apply grease to the splines of the clutch disc, then install the clutch disc using the special tools as shown.
NOTE: Use only Super High Temp Urea Grease.
3. Install the pressure plate and the mounting bolts finger-tight.
