CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
10. Adjust the length of the driveshafts to the figure below, then adjust the boots to halfway between full compression and full extension.
NOTE: The ends of boots seat in the groove of the driveshaft and joint.
-
M/T model:
Left/Right: 486 - 491 mm (19.1 - 19.3 inch).
-
A/T model:
Left: 845 - 850 mm (33.3 - 33.5 inch).
Right: 486 - 491 mm (19.1 - 19.3 inch).
11. Install new boot bands on the boots, and bend both sets of locking tabs.
12. Lightly tap on the doubled-over portions to reduce their height.
13. Position the dynamic damper as shown below.
-
Install a new dynamic damper band, and bend down both sets of locking tabs.
-
Lightly tap on the doubled-over portion of the band to reduce its height.