CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
1. Install the thrust washer, needle bearing, 1st gear, friction damper, synchro ring, and synchro spring.
NOTE: Reassemble the 1st gear and friction damper before installation.
2. Install the 1st/2nd synchro hub by aligning the friction damper fingers with 1st/2nd synchro hub grooves.
3. Install the friction damper on the spacer using the special tools and a press as shown.
4. Install the needle bearing and the ball bearing using a special tool and a press as shown.