CL L4-2156cc 2.2L SOHC F22B1 MFI (1997)
Mainshaft: Testing and Inspection
CLEARANCE INSPECTION
NOTE: If replacement is required, always replace the synchro sleeve and hub as a set.
1. Support the bearing inner race with a socket, and push down on the mainshaft.
2. Measure the clearance between 2nd and 3rd gears.
-
Standard: 0.06 - 0.21 mm (0.002 - 0.008 inch)
-
Service Limit: 0.3 mm (0.01 inch)
3. If the clearance is more than the service limit, measure the thickness of 3rd gear.
-
Standard: 32.42 - 32.47 mm (1.276 - 1.278 inch)
-
Service Limit: 32.3 mm (1.27 inch)
-
If the thickness of 3rd gear is less than the service limit, replace 3rd gear with a new one.
-
If the thickness of 3rd gear is within the service limit, replace the 3rd/4th synchro hub with a new one.
4. Measure the clearance between 4th gear and the spacer collar.
-
Standard: 0.06 - 0.21 mm (0.002 - 0.008 inch)
-
Service Limit: 0.3 mm (0.01 inch)