CL L4-2254cc 2.3L SOHC (VTEC) MFI (1998)
_mfi/Page-4557001.png)
Power Door Lock Actuator: Testing and Inspection
Driver's Door Lock Actuator Test
1. Remove the driver's door panel.
2. Disconnect the 6P connector from the actuator.
3. Check actuator operation by connecting power and ground according to the table.
CAUTION: To prevent damage to the actuator, apply battery voltage only momentarily.
4. If the actuator fails to work properly, replace it.
5. Check for continuity between the terminals in each switch position according to the table.
