CL V6-3.0L SOHC (VTEC) (1999)
Crankshaft: Testing and Inspection
Crankshaft Inspection
INSPECTION
-
Clean the crankshaft oil passages with pipe cleaners or a suitable brush.
-
Check the keyway and threads.
Alignment
-
Measure runout on all main journals to make sure the crankshaft is not bent.
-
The difference between measurements on each journal must not be more than the service limit.
Crankshaft Total runout:
Standard (New): 0.020 mm (0.0008 inch)maximum
Service Limit: 0.030 mm (0.0012 inch)
Out-of-Round and Taper
-
Measure out-of-round at the middle of each rod and main journal in two places.
-
The difference between measurements on each journal must not be more than the service limit.
Journal Out-of-Round:
Standard (New): 0.005 mm (0.0002 inch)maximum
Service Limit: 0.010 mm (0.0004 inch)
-
Measure taper at the edges of each rod and main journal.