CL TYPE S V6-3.2L SOHC (2001)
Paint: Service and Repair
Treatment of Metal Surface
Treatment of Metal Surface
1. Filling/drying
Small cracks or pinholes in the sheet metal should be repaired with a body filler and sanded flat and smooth.
-
Use a 2-part polyester resin putty.
-
Mix the putty with the hardener in the correct ratio.
-
Follow the body filler manufacturer's instructions.
-
Mix the body filler and hardener quickly.
-
Apply the body filler in several thin coats, without air bubbles.
-
Do not try to cover the surface with one heavy coat.
-
Apply the body filler over the damaged area with a putty knife using light pressure.
-
After applying the body filler, allow 5 to 6 minutes of normal drying time, then force dry it with infrared lamps or an industrial dryer at 122
degrees F (6 degrees C).
NOTE: Follow the body filler manufacturer's instructions for drying time.
2. Polishing
The body filler is dry when a white mark appears after the surface is scratched with your finger nail.