CL TYPE S V6-3.2L SOHC (2001)
Paint: Service and Repair
Undercoating
Undercoating
1. Masking
Mask the area surrounding the damage to prevent over spray from the primer surfacer.
Use masking tape and paper.
2. Spraying the primer surfacer
-
Spray the primer surfacer over a wider area than the body filler and the exposed surface of the paint film.
-
Spray 2-3 coats to get 30 microns of thickness.
-
Use a 2-part urethane primer surfacer and a spray gun.
-
Mix the primer surfacer with the additive and solvent, and in the correct ratio.
-
Follow the primer surfacer manufacturer's instructions.
3. Drying
After spraying the primer surfacer, allow for 5 to 10 minutes of normal drying time, then force dry it with infrared lamps or an industrial dryer.
NOTE: Follow the primer surfacer manufacturer's instructions for drying time.
4. Polishing
Check that the primer surfacer has dried thoroughly, then sand the primer surfacer.
Use a double action sander and #320-#400-#600 disc sandpaper.
5. Air blowing / degreasing