CL TYPE S V6-3.2L SOHC (2001)
Use Kwik-Way cutting bits, P/N KWY-109109223, and the holding screws that come with them. These bits are stamped KW and are available through
the Acura Tool and Equipment Program (see ORDERING INFORMATION).
Before you use the brake lathe, inspect the tips of the cutting bits with a magnifying glass to make sure the tips are not worn out. Each bit has three tips.
If a tip is worn, rotate the bit, and use a new tip. A worn tip produces a poor finish and may cause chattering.
Reinstall the tool bed on the brake lathe with the top of the cutting bits facing up and the feed knobs facing down. Adjust the tool bed until the brake disc
is centered between the cutting bits. For proper refinishing, the brake disc must turn toward the top of the cutting bits.
Do not set the cutting depth on the brake lathe to more than 0.2 mm (0.008 in.) This is two divisions on the cutting knob. Make sure you start your cut at
least 3 mm (0.12 in.) beyond the worn area on the brake disc.
