CL TYPE S V6-3.2L SOHC (2001)
2. Attach the mounting yoke to the brake disc, and secure it with one of the wheel nuts. Torque the wheel nut to the required specification (see the
appropriate service manual).
3. Attach the driveshaft on the drive motor assembly to the mounting yoke, making sure the center line of the driveshaft is level with the spindle nut on
the wheel hub.
4. Set the lower toggle switch on the drive motor assembly to FWD (counterclockwise rotation) or REV (clockwise rotation).
Setting Up and Adjusting the Brake Lathe
