CL TYPE S V6-3.2L SOHC (2001)
Vacuum Brake Booster: Adjustments
Master Cylinder Pushrod Clearance Adjustment
Special Tools Required
Pushrod adjustment gauge 07JAG-SD40100
NOTE: Master cylinder pushrod-to-piston clearance must be checked and adjustments made, if necessary, before installing the master cylinder.
1. Set the special tool (A) on the master cylinder body (B), push in the center shaft (C) until the end of it contacts the end of the secondary piston (D)
by turning the adjusting nut (E).
2. Without disturbing the center shaft's position, install the special tool (A) onto the booster.
3. Install the master cylinder nuts (B), and tighten them to the specified torque values.
4. Connect the booster in-line with a vacuum gauge (C) 0 - 101 kPa (0 - 760 mm Hg, 30 inch Hg) to the booster's engine vacuum supply, and
maintain the engine speed that will deliver 66 kPa (500 mm Hg, 20 inch Hg) vacuum.
5. With a feeler gauge (A), measure the clearance between the gauge body and the adjusting nut (B) as shown. If the clearance between the gauge
body and adjusting nut is 0.4 mm (0.02 inch), the pushrod-to-piston clearance is 0 mm. However, if the clearance between the gauge body and
adjusting nut is 0 mm, the pushrod-to-piston clearance is 0.4 mm (0.02 inch) or more. Therefore it must be adjusted and rechecked.
Clearance: 0 - 0.4 mm (0 - 0.02 inch)
