CL TYPE S V6-3.2L SOHC (2001)
16. Check for continuity between body ground and PCM connector terminals B20 and B22.
Is there continuity between ground and each terminal?
YES - Go to step 17.
NO - Repair open in the wire(s) between PCM connector terminal B20 or B22 and ground (G101). Repair poor ground (G101).
17. Turn the ignition switch ON (II).
18. Measure the voltage between PCM connector terminals B1 and B22, and between terminals B9 and B20.
Is there battery voltage?
YES - Go to step 19.
NO - Repair open or short in the wire between PCM connector terminal B1 or B9 and the PGM-FI main relay.
19. Turn the ignition switch OFF.
20. Reconnect PCM connector B (25P).
21. Connect a digital multimeter between PCM connector terminals A14 and B20 or B22.
22. Turn the ignition switch ON (II).
Is there voltage for at least 2 seconds?
YES - Check for an open in the wire between PCM connector terminal A14 and the gauge assembly. If the wire is OK, check for a faulty D5
indicator bulb or a faulty printed circuit board in the gauge assembly.
NO - Go to step 23.
23. Turn the ignition switch OFF.
24. Disconnect PCM connector A (32P).
