CL TYPE S V6-3.2L SOHC (2001)
Transmission Shift Position Indicator Lamp: Testing and Inspection
Indicator Input Test
Test
SRS components are located in this area. Review the SRS component locations, precautions and procedures in SRS before performing repairs or
service.
1. Remove the gauge assembly from the dashboard, then disconnect the A (30P) and C (14P) connectors from the gauge assembly.
2. Inspect the connectors and connector terminals to be sure they are making good contact.
3. If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
4. Perform the following input test at the gauge assembly A (30P) and C (14P) connectors.
GAUGE ASSEMBLY CONNECTORS
Wire side of female terminals