CL TYPE S V6-3.2L SOHC (2001)
9. Check for continuity between DLC terminal No.15 and ECM terminal E27.
Is there continuity?
YES - Update the ECM if it does not have the latest software, or substitute a known-good ECM, then recheck. If the symptom/indication goes
away with a known-good ECM, replace the original ECM.
NO - Repair open in the wire between DLC terminal No. 15 and the ECM (E27). After repairing the wire, check the DTC with the OBD II scan
tool/Honda PGM Tester, then go to the DTC Troubleshooting Index.
10. Turn the ignition switch OFF.
11. Disconnect ECM connector E (31P). Make sure the OBD II scan tool or Honda PGM Tester is disconnected from the DLC.
12. Turn the ignition switch ON (II).
13. Measure voltage between DLC terminals No.13 and No.15.
Is there 0 V?
YES - Update the ECM if it does not have the latest software, or substitute a known-good ECM, then recheck. If the symptom/indication goes
away with a known-good ECM, replace the original ECM.
NO - Repair short to power in the wire between DLC terminal No.15 and the ECM (E27). After repairing the wire, check the DTC with the OBD
II scan tool/Honda PGM Tester, then go to the DTC Troubleshooting Index.
