CL TYPE S V6-3.2L SOHC (2001)
Seat Belt Tensioner: Service and Repair
Deploying the Airbags/Tensioner (Inside Vehicle)
Airbag Disposal
Special Tool Required
Deployment tool 07HAZ-SG00500
Before scrapping any airbags, side airbags, or seat belt tensioners (including those in a whole vehicle to be scrapped), the airbags, side airbags, or seat
belt tensioners must be deployed. If the vehicle is still within the warranty period, the Acura District Parts and Service Manager must give approval
and/or special instruction before deploying the airbags, side airbags, or seat belt tensioners. Only after the airbags, side airbags, or seat belt tensioners
have been deployed (as the result of vehicle collision, for example), can they be scrapped. If the airbags, side airbags, or seat belt tensioners appear intact
(not deployed), treat them with extreme caution. Follow this procedure.
Deploying Airbags in the Vehicle
If an SRS equipped vehicle is to be entirely scrapped, its airbags, side airbags, or seat belt tensioners should be deployed while still in the vehicle. The
airbags, side airbags, or seat belt tensioners should not be considered as salvageable parts and should never be installed in another vehicle.
1. Turn the ignition switch OFF, then disconnect the battery negative cable, and wait at least 3 minutes.
2. Confirm that each airbag, side airbag, or seat belt tensioner is securely mounted.
3. Confirm that the special tool is functioning properly by following the check procedure on the tool label.
Driver's Airbag:
4. Remove the access panel (A), then disconnect the 2P ('01-02 models) or 4P ('03 model) connector between the driver's airbag (B) and the cable
reel (0.
Front Passenger's Airbag:
5. Remove the glove box, then disconnect the 4P connector between the front passenger's airbag (A) and the SRS main harness (B).
Side Airbag: