CL TYPE S V6-3.2L SOHC (2001)
Power Seat Motor Position Sensor: Testing and Inspection
Power Seat Position Sensor Troubleshooting
Power Seat Position Sensor Troubleshooting
Slide Position Sensor:
1. Remove the driver's power seat mounting bolts.
NOTE: Be careful to not scratch the interior trims.
2. Disconnect the 3P connector from the slide position sensor and the 20P connector from the driver's power seat control unit.
3. Check for continuity between the No. 2 terminal of the slide position sensor and A11 terminal of the power seat control unit.
Is there continuity?
YES - Go to step 4.
NO - Repair open in the WHT/BLK wire.
4. Check for voltage between the No. 3 terminal of the slide position sensor and body ground.
Is there about 5 V?
YES - Go to step 7.
NO - Repair the open or the short in the BRN wire.
5. Check for continuity between the No. 1 terminal of the slide position sensor and A2 terminal of the power seat control unit.
Is there continuity?
YES - Go to step 6.
NO - Repair open in the BLU/BLK wire.
