CL TYPE S V6-3.2L SOHC (2001)
3. Press the intermediate shaft (A) out of the intermediate shaft bearing (B) using the special tools and a press. Be careful not to damage the bearing
support rings (C) on the intermediate shaft during disassembly.
4. Remove the internal snap ring.
5. Press the intermediate shaft bearing (A) out of the bearing support (B) using the special tools and a press.
Reassembly
Special Tools Required
-
Driver 07749-0010000
-
Support base attachment 07LAF-SM40300
-
Support base 07965-SD90100
-
Oil seal driver attachment 07947-SD90101
-
Fork seal driver, 39.2 x 49.5 x 15 mm 07947-4630100
NOTE: Refer to the Exploded View as needed during this procedure.
1. Clean the disassembled parts with solvent, and dry them with compressed air. Do not wash the rubber parts with solvent.
