CL TYPE S V6-3.2L SOHC (2001)
the rear window as shown. If necessary, apply primer (3M N-200, or equivalent) to the areas where the window antenna terminal base (C) will be
glued, then glue the base with adhesive tape (3M 4211, or equivalent) on:
-
Be sure the fasteners (and window antenna terminal base cover) line up with the alignment marks (D).
-
Be careful not to touch the rear window where adhesive will be applied.
14. Apply the adhesive tape (A) (3M 4216, or equivalent) to the edge of the rear window (B):
-
Be sure the adhesive tape lines up with the alignment marks (C).
-
Be careful not to touch the rear window where adhesive will be applied.
15. Glue the molding (A) around the edge of the rear window (B):
-
Be sure the joint (C) lines up with the alignment mark (D).
-
Be careful not to touch the rear window where adhesive will be applied.
16. Install the clips to the body.