CL TYPE S V6-3.2L SOHC (2001)
17. Set the rear window in the opening, and center it. Make alignment marks (A) across the rear window and body with a grease pencil at the four
points shown. Be careful not to touch the rear window where adhesive will be applied.
18. Remove the rear window.
19. With a sponge, apply a light coat of glass primer along the edge of the rear window (A) and molding (B) as shown, then lightly wipe it off with
gauze or cheesecloth:
-
Do not apply body primer to the rear window, and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the rear window properly, causing a leak after the
rear window is installed.
-
Keep water, dust, and abrasive materials away from the primed surface.
20. With a sponge, apply a light coat of body primer to the original adhesive remaining around the rear window opening flange. Let the body primer
dry for at least 10 minutes:
