CL TYPE S V6-3.2L SOHC (2001)
-
Be careful not to touch the quarter glass where adhesive will be applied.
-
Do not peel the separator off the butyl tapes.
8. If the old quarter glass is to be reinstalled (and any of the clips are broken off the molding), seal the body holes with pieces of urethane tape (A).
Then set the quarter glass upright in the opening, and make alignment marks (B) across the quarter glass and body with a grease pencil at the three
points shown. Be careful not to touch the quarter glass where adhesive will be applied.
9. Remove the quarter glass.
10. With a sponge, apply a light coat of glass primer to the inside face of the quarter glass (A) as shown, then lightly wipe it off with gauze or
cheesecloth:
-
Do not apply body primer to the quarter glass, and do not get body and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the quarter glass properly, causing a leak after the
quarter glass is installed.
-
Keep water, dust, and abrasive materials away from the primed surface.
