Integra L4-1590cc 1.6L DOHC FI (1987)
Blower Motor: Service and Repair
Blower Unit Removal and Installation
Fig. 19 Exploded view of blower housing assembly. Integra
Less A/C
1.
Disconnect battery ground cable.
2.
Remove glove box, glove box frame and blower duct.
3.
Disconnect electrical connector from blower motor.
4.
Remove three housing retaining bolts and the housing.
5.
Separate blower housing and remove impeller from motor shaft, Fig. 19.
6.
Remove motor mounting screws and the motor.
7.
Reverse procedure to install.
Fig. 20 Blower housing installation. Integra with A/C, models less A/C similar
With A/C
1.
Disconnect battery ground cable.
2.
Remove glove box and glove box frame.
3.
Remove two bolts securing headlamp retractor control, the control and bracket, Fig. 20.
4.
Remove center console as follows:
a. Raise parking brake lever and, on manual transaxle models, remove shift knob.
b. Pry up screw covers from front and rear of brake lever housing, then remove retaining screws.
c. Remove two retaining screws from each side of console, then the console assembly.
5.
Remove console box bracket.