Integra L4-1678cc 1.7L DOHC (VTEC) FI (1992)
_fi/Page-2304004.png)
2.
Apply suitable grease to cam boot, then install the boot in caliper.
3.
Install cam, ensuring hole in cam faces cylinder.
4.
Install lever, spring washer and parking nut. Torque nut to specifications, then install return spring.
5.
Install rod in cam, then position new O-ring on sleeve piston or pushrod.
6.
On Integra models, install sleeve piston. Ensure hole in bottom of piston is properly aligned with rod in cam and two pins on piston are
aligned with holes in caliper.
7.
On 1989-90 Legend models, install pushrod and key plate in cylinder. Ensure hole in pushrod aligns with rod, cut-out in key plate aligns
with square portion of pushrod and lug on key plate aligns with hole in cylinder.
8.
On Integra models, install new cup with cup groove facing bearing side on adjusting bolt, then position bearing, spacer, adjusting spring and
spring cover on adjusting bolt. Install adjusting bolt assembly into caliper cylinder.
9.
On 1989-90 Legend models, depress pushrod and install retaining ring, then the seat, spring and spring cover on pushrod.
10.
On all models, position rear caliper guide tool No. 07973-SA50000 on Integra models, or No. 07GAE-SD40200 on Legend models, or equivalent
in cylinder, ensuring cutout on tool aligns with tab on spring cover.
Fig. 11 Brake Spring Installation
Fig. 12 Brake Spring Installation
