Integra GS-R L4-1797cc 1.8L DOHC (VTEC) PGM-FI (2001)
_pgm-fi/Page-2894003.png)
2. Remove the oil seal from the transmission housing.
3. Remove the oil seal from the clutch housing.
BEARING OUTER RACE REPLACEMENT
CAUTION: Do not reuse the thrust shim and the 79.5 mm shim if the outer race was driven out.
NOTE: The bearing outer race and tapered roller bearing should be replaced as a set. Inspect and adjust the tapered roller bearing preload whenever
the tapered roller bearing is replaced.
1. Remove the oil seals from the transmission housing and clutch housing.
