Integra GS-R L4-1797cc 1.8L DOHC (VTEC) PGM-FI (2001)
4. Install the new thrust shim and 79.5 mm shim, then drive the bearing outer races in the both housings using the special tools as shown.
NOTE:
-
Install the bearing outer race squarely.
-
Check that there is no clearance between the bearing outer race, thrust shim, and transmission housing.
5. Install the oil seal.
TAPERED ROLLER BEARING PRELOAD ADJUSTMENT
NOTE: If any of the items listed below were replaced, the tapered roller bearing preload must be adjusted.
-
Transmission housing
-
Clutch housing
-
Differential carrier
-
Tapered roller bearing and bearing outer race
-
Thrust shim
1. Remove the bearing outer race, the thrust shim, and the 79.5 mm shim from the transmission housing.
CAUTION: Do not reuse the thrust shim if the bearing outer race was driven out.