Integra GS-R L4-1797cc 1.8L DOHC (VTEC) PGM-FI (2001)
_pgm-fi/Page-2895005.png)
7. If the clearance is not within the standard, select a new 80 mm shim from the table.
Standard: 0 - 0.10 mm (0.004 inch)
NOTE: If the clearance measured in step 6 is within the standard, it is not necessary to go to step 9.
8. Remove the bolts and transmission housing.
9. Replace the 80 mm shim selected in step 7, then recheck the clearance.
10. Reassemble the transmission and install the transmission housing.
OIL SEAL INSTALLATION
