Integra GS-R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (1997)
_mfi/Page-2968007.png)
Spring Cover And Adjusting Bolt
9. Fit the bearing A, spacer, adjusting spring B and spring cover on the adjusting bolt, then install them in the caliper body.
Brake Spring Compressor And Shaft
10. Install the special tool on the spring cover and turn the shaft until the locknut contacts the plate.
Special Tool:
Brake Spring Compressor # 07HAE-SG00100
11. Check that the flared end of the spring cover is below the circlip groove.
