Integra GS-R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (1997)
Install Circlip
12. Install the circlip in the groove then remove the special tool.
Special Tool:
Snap Ring Pliers # 07914-SA50000
NOTE: Check that the circlip is seated in the groove properly.
13. Coat a new piston seal with silicone grease and install it in the caliper.
Piston Seal And Piston Boot
14. Apply brake cylinder grease (P/N: 08733-B020E) or equivalent rubber grease to the sealing lips and inside of a new piston boot then install it in
the caliper.
15. Coat the outside of the piston with brake fluid and install it on the adjusting bolt while rotating it clockwise with the special tool (locknut wrench).
CAUTION: Avoid damaging the piston and the piston boot.