Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
11. If you can feel a ridge of metal or hard carbon around the top of each cylinder, remove it with a ridge reamer. Follow the reamer manufacturer's
instructions.
CAUTION: If the ridge is not removed, it may damage the pistons as they are pushed out.
12. Use the wooden handle of a hammer to drive the pistons out.
CAUTION: Take care not to damage the contact surface of the metal gasket.
13. Reinstall the rod bearings and caps after removing each piston/connecting rod assembly.
14. Mark each piston/connecting rod assembly with its cylinder number to avoid mix-up on reassembly.
NOTE: The existing number on the connecting rod does not indicate its position in the engine, it indicates the rod bore size.
