Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
10. Check the front hub for damage or cracks.
11. Remove the wheel sensor wire bracket, then remove the wheel sensor from the steering knuckle (for cars with ABS).
NOTE: Do not disconnect the wheel sensor connector. Use ball joint remover, 28 mm, to separate the ball joints from the suspension or tie-rod
end.
CAUTION: Be careful not to damage the ball joint boot.
12. Clean any dirt or grease off the ball joint.
13. Remove the cotter pin from the tie-rod end ball joint castle nut, and remove the nut.
14. Apply grease to the special tool on the areas shown. This will ease installation of the tool and prevent damage to the pressure bolt threads.
15. Install a 10 mm hex nut on the ball joint. Be sure that the hex nut is flush with the ball joint pin end to prevent damage to the threaded end of the
ball joint.