Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
25. Install the 12 mm hex nut on the ball joint. Be sure that the hex nut is flush with the ball joint pin end, or the threaded section of the ball joint pin
might be damaged by the ball joint remover.
26. Use the special tool to separate the ball joint and steering knuckle.
NOTE: If necessary, apply penetrating type lubricant to loosen the ball joint.
27. Pull the steering knuckle outward and remove the driveshaft outboard joint from the steering knuckle using a plastic hammer, then remove the
steering knuckle.