Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
CAUTION: Do not over-expand the valve seal ring.
7. Apply power steering fluid to the surface of the valve seal ring that was installed on the pinion shaft.
8. Apply power steering fluid to the inside of the special tool. Set the larger diameter end of the special tool over the valve seal ring.
9. Move the special tool up and down several times to make the valve seal ring fit in the pinion shaft.
10. Remove the special tool.
11. Turn the special tool over and set the smaller diameter end of the special tool over the valve seal ring. Move the special tool up and down several
times to make the valve seal ring snugly fit in the pinion shaft.
12. Apply power steering fluid to the surface of the special tool. Set the new seal rings over the special tool from the smaller diameter end of the tool,
and expand the seal rings. Do two rings at a time from each end of the sleeve.
NOTE:
-
Do not over-expand the sleeve seal ring. Install the resin seal rings with care so as not to damage them. After installation, be sure to contract
the sleeve seal rings using the special tool (sizing tool).
-
There are two types of sleeve seal rings: black and brown. Do not mix the different types of sleeve seal rings as they are not compatible.
13. Set the special tool in the grooves in the sleeve, and set each ring in each groove securely.
NOTE: After installation, compress the seal rings with your fingers temporarily.
14. Apply power steering fluid to the sleeve seal rings on the sleeve and to the entire inside surface of the special tool.
15. Insert the sleeve into the special tool slowly as shown.
