Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
16. Move the sleeve each direction several times to make the seal rings snugly fit in the sleeve groove.
NOTE: Be sure that the seal rings are not turned up.
17. Apply power steering fluid to the surface of the pinion shaft, then assemble the sleeve over the pinion shaft, aligning the locating pin on the inside
of the sleeve with the cutout in the shaft.
NOTE: Be careful not to damage the valve seal ring when inserting the sleeve.
18. Install the circlip securely in the pinion shaft groove.
NOTE: Install the circlip with its radiused side facing out.
19. Apply power steering fluid to the seal ring lip of the valve oil seal. Then install the seal in the valve housing using a hydraulic press and special
tools as shown.