Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Shift Cable: Adjustments
CAUTION:
-
All SRS wire harnesses are covered with yellow insulation. Before you disconnect any part of an SRS wire harness. disconnect the airbag
connectors.
-
Whenever the ignition switch is ON (II), or has been turned OFF for less than three minutes, be careful not to bump the SRS unit; the airbags
could accidentally deploy and cause damage or injuries.
-
For additional precautions, refer to the SRS section.
WARNING: Make sure lifts are placed properly.
1. Remove the center console.
2. Shift to N position, then remove the lock pin from the cable adjuster.
3. Check that the hole in the adjuster in perfectly aligned with the hole in the shift cable.
NOTE: There are two holes in the adjuster. They are positioned 90° apart to allow cable adjustment in 1/4 turn increments.
