Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
4. If the hole is not perfectly aligned, loosen the locknut on the adjuster, and adjust as required.
5. Tighten the locknut to 7 Nm (5 ft. lbs.).
6. Install the lock pin on the adjuster. If you feel the lock pin binding as you reinstall it, the cable is still out of adjustment and must be readjusted.
7. Make sure the lock pin is seated securely in the adjuster.
8. Move the shift lever to each gear, and verify that the automatic transaxle gear position indicator follows the automatic transaxle gear position
switch.
9. Start the engine, and check the shift lever in all gears. If any gear does not work properly, refer to troubleshooting.
10. Insert the ignition key into the key cylinder on the shift indicator panel, verify that the shift lock lever is released.
