Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
CAUTION: Remove the gears using a press and the steel blocks as shown. Use of a jaw-type puller can cause damage to the gear teeth.
5. Support 4th gear on steel blocks, and press the countershaft out of 5th and 4th gears, as shown.
ASSEMBLE
CAUTION:
-
Press 4th and 5th gears on the countershaft without lubrication.
-
When installing 4th and 5th gears, support the shaft on steel blocks, and install the gears using a press.
-
Install 4th and 5th gear with a maximum pressure of 25.5 kN (18,806 lbs.).
NOTE: Refer to exploded view for reassembly sequence.
1. Install the thrust shim and the needle bearings on the countershaft.
2. install the friction damper, the synchro ring, and the synchro spring on 1st gear.
