Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
3. Install the 1st/2nd synchro hub by aligning the fingers on the friction damper and the grooves in the 1st/2nd synchro hub, as shown.
4. Install the reverse gear.
5. Install the synchro spring, and the synchro ring as shown.
6. Assemble the friction damper, the needle bearing and 2nd gear, then install them by aligning the fingers on the friction damper and the grooves in
the 1st/2nd synchro hub with the fingers of the clout cone synchro and the grooves on 2nd gear, shown.
7. Install the spacer.
8. Install the parts assembled in steps 2 - 6 on the countershaft.
