Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
20. Position the piston at TDC and insert an air adaptor into the spark plug hole. Pump air into the cylinder to keep the valve closed while
compressing springs and removing the valve keepers.
21. Position the lever arm under the cross shaft so the lever is perpendicular to the shaft and the compressor attachment rests on top of the retainer for
the spring being compressed. Use the rear position slot on the lever as shown.
NOTE: Put shop towels over the oil passages to prevent the valve keepers from falling into the cylinder head.
22. Using a downward motion on the lever arm, compress the valve spring and remove the keepers from the valve stem. Slowly release pressure on the
spring.
23. Repeat step 22 for the Other valve in that cylinder.
24. Remove the valve seals.
25. Install the valve seals.
26. Install the springs, the retainers and the keepers in reverse order of removal.
27. Repeat steps 20 to 26 on the other three cylinders.
