Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
21. Apply vinyl tape to the pinion shaft, then coat the vinyl tape with power steering fluid.
22. Insert the pinion shaft into the valve housing.
CAUTION: Be careful not to damage the valve seal rings.
23. Remove the vinyl tape from the pinion shaft.
24. Press the pinion shaft/sleeve into the valve housing using a hydraulic press as shown.
NOTE: Check that the pinion shaft/sleeve turns smoothly by turning the pinion shaft with your hand.
Steering Rack
25. Coat the special tool with power steering fluid, and slide it onto the rack, big end first.
26. Position the new O-ring and new piston seal ring on the special tool, then slide them down towards big end of the tool.
NOTE:
-
Do not over expand resin seal rings. Install the resin seal ring with care so as not to damage them. After installation, be sure to contract the seal
ring using the special tool (sizing tool).
-
Replace piston's O-ring and seal ring as a set.