Integra Type R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (2001)
_mfi/Page-3412003.png)
11. Drill a 3 mm (0.12 inch) diameter hole approximately 2.5 - 3.5 mm (0.10 - 0.14 inch) in depth in the staked point on the cylinder.
NOTE: Do not allow metal shavings to enter the cylinder housing.
12. Install a puller yoke to the steering gearbox. Clamp the puller yoke in a vise with soft jaws as shown, then loosen and remove the cylinder end.
13. Set the gearbox in a press so the gearbox housing points upward.
14. Install the flange bolt into the end of the steering rack until it bottoms in the hole, then back the flange bolt out 1/4 turn. Hold the flange bolt and
tighten the flange nut against the rack by hand.
15. Press the cylinder end seal and steering rack out of the gearbox.
NOTE: Hold the steering rack to keep it from falling when pressed clear.
