Integra Type R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (2001)
_mfi/Page-3412004.png)
16. Remove the flange bolt and cylinder end seal from the steering rack.
17. Insert a 24" long, 3/8" drive extension, and the special tool into the cylinder from the gearbox side.
CAUTION: Be careful not to damage the inside surface of the housing with the tools.
18. Set the gearbox in a press, then press out the cylinder end seal and backup ring from the gearbox.
CAUTION:
-
Keep the tool straight to avoid damaging the cylinder wall. Check the tool angle, and correct if necessary, when removing the cylinder end
seal.
-
Use a press to remove the cylinder end seal. Do not try to remove the seal by striking the tool. It will break the backup ring and the cylinder
end seal will remain in the gearbox.
19. Carefully pry the piston seal ring and O-ring off the piston of the rack.
CAUTION: Be careful not to damage the inside of seal ring groove when removing the seal ring.
20. Apply vinyl tape-to the pinion shaft.
