Integra Type R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (2001)
_mfi/Page-3412016.png)
CAUTION: When installing the cylinder end seal, be careful not to damage the sealing lip face of the seal with the edges of the steering rack.
43. Remove the vinyl tape from the steering rack, then push in the cylinder end seal with your finger.
NOTE:
-
Remove any residue of tape adhesive.
-
Take care not to damage the cylinder end seal with the threads and burrs at the staked position of the gearbox.
44. Install a puller yoke to the steering gearbox, then clamp the puller yoke in a vise with son jaws as shown.
45. Grease the inside surface of the cylinder end, then install the cylinder end by screwing it into the cylinder.
46. After tightening the cylinder end, stake the point of the cylinder housing shown.
NOTE: Stake in the cylinder in the position opposite from where the stake was removed during disassembly.
47. Coat the new O-ring with grease and install it in the groove in the gearbox housing.
48. Apply grease to the needle bearing in the gearbox housing.