Integra Type R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (2001)
_mfi/Page-2875002.png)
Welded Type
Double Loop Type
3. Make a mark on each roller and inboard joint to identify the locations of rollers and grooves in the inboard joint. Then remove the inboard joint on
the shop towel. Be careful not to drop the rollers when separating them from the inboard joint.
4. Make a mark on the rollers and spider to identify the locations of rollers on the spider, then remove the rollers.
5. Remove the circlip.
6. Mark the spider and driveshaft to identify the position of the spider on the shaft.
