Legend Coupe V6-2675cc 2.7L SOHC FI (1988)
6.
Remove the backing from tricot tape and carefully wrap the tape around both edges of the sunshade as shown.
7.
Pull back the front edge of the Sunroof Trim and apply several light dabs of clear silicone sealer on the top forward edge of the sunroof frame.
Clean any excess sealer off the frame.
CAUTION: Do not allow the sealer to mar the headliner.
8.
On the Legend Coupe, reinstall the sunroof shade and the sunroof glass.
NOTE:
Steps 9 through 12 apply to the '86 & 87 4-door only:
9.
Make two "spacers" out of EPT sealer and sliptape. For each spacer, cut two 1/2" x 2" pieces of EPT 10T sealer and stick them together,
piggyback style, as shown. Then install a length of sliptape over the "bottom" or non-adhesive part of the spacer.
NOTE:
The slip-tape must he wider than the spacer and long enough to wrap halfway up the spacer at each end.
10.
Position the sunroof drain channel fully forward.
NOTE:
To move the drain channel forward, have an assistant hold up the front edge of each rear mount bracket while you move the sunroof
mechanism with the sunroof wrench.
