Legend Coupe V6-2675cc 27L SOHC FI (1988) | Brake Caliper Service and Repair Front | Page 4634
4.
Remove caliper mounting bolts and the caliper, Fig. 9.
5.
Remove pad spring from caliper.
6.
Remove piston and piston boot using needle-nose pliers. Rotate piston as it is removed.
7.
On Integra models, remove circlip, washer, adjusting spring and adjusting nut from piston.
8.
On Legend models, remove retaining ring, spacer, wave washer, spacer, ball bearing, adjuster nut and cup from piston.
9.
On all models, carefully pry piston seal out of caliper bore.
Fig. 11 Brake spring removal. Legend
10.
Position brake spring compressor tool between caliper body and spring cover, Fig. 11.
11.
Turn shaft of tool to compress adjusting spring, then remove circlip or retaining ring.
12.
On Integra models, remove spring cover, adjusting spring, spacer, bearing, adjusting bolt, sleeve piston and rod.
13.
On Legend models, remove spring compressor, then the spring cover, spring, seat, retaining ring, key plate, push rod and rod from caliper.
Remove O-ring from push rod.
14.
On all models, remove return spring, parking nut, spring washer, lever, cam and cam boot.
Assembly & Installation
1.
Pack needle bearing with suitable grease.
2.
Apply suitable grease to cam boot, then install the boot in caliper.
3.
Install cam, ensuring hole in cam faces cylinder.
4.
Install lever, spring washer and parking nut. Torque nut to 20 ft. lbs., then install return spring.
5.
Install rod in cam, then position new O-ring on sleeve piston or push rod.
6.
On Integra models, install sleeve piston. Ensure hole in bottom of piston is properly aligned with rod in cam and two pins on piston are
aligned with holes in caliper.
7.
On Legend models, install push rod and key plate in cylinder. Ensure hole in push rod aligns with rod, cut-out in key plate aligns with square
portion of push rod and lug on key plate aligns with hole in cylinder.
8.
On Integra models, install new cup with cup groove facing bearing side on adjusting bolt, then position bearing, spacer, adjusting spring and
spring cover on adjusting bolt. Install adjusting bolt assembly into caliper cylinder.
9.
On Legend models, depress push rod and install retaining ring, then the seat, spring and spring cover on push rod.
10.
On all models, position rear caliper guide tool No. 07973-SA50000 on Integra models or No. 07GAE-SD40200 on Legend models, or equivalent
in cylinder, ensuring cutout on tool aligns with tab on spring cover.
